Canton Digital Movie 50 Instructions d'exploitation télécharger pdf (Page 61)

DeutschEnglish

Service Setup Menu

The Service Setup mode of the DM remote control is accessed by

pressing and holding the MENU key, simultaneously pressing the

Power key and releasing them both at the same. The following

functions can be set here: i2C, Start-up Volume, Volume Limiter and

Preset.

i2C

This is used to switch off the internal control of the Canton system

for servicing. After automatic shut-down of the remote control,

reactivation is only possible by disconnecting the sub from the mains

for 10 seconds. For this reason, please ensure that the setting is

always in the „on“ position.

Start-up Volume

This value determines the maximum volume when the DM system is

switched on. If the device is switched off at a lower volume, this

level is maintained.

Volume Limiter

The maximum settable and achievable volume is set here in order to

prevent an unintentionally high level.

Preset

Preset determines the mode in which your DM system is operated.

The display differentiates between function-specific and product-

specific properties.

2.1 (delivery status) or 5.1 mode can appear as functions. The

option exists in 5.1 mode of operating an active or wireless

loudspeaker system via the „2.1 MODE/5.1 MODE“ pre-amplifier

output. If „5.1 Mode DM 2“ is selected, an additional passive center

speaker is required which should be connected at the „Center“

output. This is not necessary in „5.1 Mode DM 1“, because the

signals are reproduced by the two front speakers.

The product-specific properties relate to the DIGITAL MOVIE system

you have purchased. Select the menu items here that match up

with your system.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Canton Digital Movie 50 Instructions d'exploitation Page 61